5 Deg Toyota Landcruiser 80 105 Castor plates Caster Correction 4'' lift and Up
or 4 payments of $44.00 with Info
- If it Shows IN STOCK- We have it in our warehouse.
- Tax Invoice for all purchases.
- Ships from Warragul, Victoria.
- Call us if you need to! We are here to help.
5 degree Castor correction plates
Toyota Landcruiser 80 1992-on & 105 series
5 Degree castor plates are used for correcting the castor on the Live axle toyota landcruiser
5 degree plates are used on 4-6 inch lifts.
ALSO AVAILABLE IN BLACK
For smaller lifts We recommend castor bushes.
Castor plates are a bolt on kit with general workshop tools required ( You will need a small Grinder).
Please note ! - If you have a Heavy duty Tie rod that is a larger Dia than factory there may be other mods required for clearance to the radius arm.
Please take note of the following The radius arms may also need to have slight modification, if the tie rod makes contact.You will not be able to tell if you need to modify the radius arm until the plates are completely fitted.The castings are slightly different in some models and wear and tear on the bushes has a governing factor on the contact area of the radius arm to tie rod.Figure 3 shows two white marks that are an approx. area that may need to have a slight grinding to the top casting area.To see if you need to modify your radius arm rotate the steering from left to right at full lock, this is done best with the wheels off the vehicle and stands under the diff.As you turn the steering lock to lock take note if the tie rod clears the radius arm with at least 4-5 mm clearance, if it is okay than you can refit the wheels, double check all the bolts are tight and test drive.If the Tie rod makes contact with the radius arm you will need to modify the radius arm.After marking the approx. area on the radius arm that needs to be ground remove the radius arm and place in a vice, carefully grind only enough to allow the clearance needed.It is recommended finish the grinding process with a sanding pad to take out any stress points that may be formed due to “rough grinding” Paint the arms and refit as per the vehicle service manual.
ALSO AVAILABLE IN BLACK
Please note this product is an aftermarket product that is designed to fit the above mentioned vehicle(s), any mention of vehicle brand or model is only to allow you to establish the correct fitment for your vehicle, and is not indicating that the part is manufactured by the original vehicle manufacturer.
|Brand||Road Runner Offroad|